PlayStation®Move

[vicbaldry]

Hello,

I recently purchased the PS3 Move navigation controller to use with my Sharpshooter gun. When I plug it in (using an official USB cable that came with my PS3) it works just fine. It appears to charge normally and I can use the buttons to control the interface etc. When I go to Settings -> Controller Assignments it is automatically assigned slot 7 (not sure if this is relevant or not)

Whenever I unplug it though, it goes dead and won't switch on, therefore making it useless if you would like to use it with the Sharpshooter. I've tried everything - resetting the controller, re-assigning the controller number, but nothing seems to work.

Do I have a defective unit, or is this a common issue? If so, is there a solution? Should I try and take it apart and replace the battery?

Thanks in advance for the help.

Vic.

[ManicLampshade]

I have this same exact issue. My Move controller works fine unplugged but I can't say the same for the Navigation controller.

EDIT: I went ahead and reset all of my controllers (Two Dual Shocks, Move and Navigation) and re-synced them. That seemed to do it for some reason. Oh well, I won't question it it. At least it's working!

[nissangod2012]

Same exact thing here. I haven't tried recetting all controllers yet , will do when i get off work at 7am, has anyone rlse find out the cause or issue why this happens? Also after charging for awhile I pressed the ps bottom which pops up the charge icon and controller # , when i did this there was a - symble instead of battery symble any ideas?